PowerEdge 840 || Adaptec

Mark Watts m.watts at eris.qinetiq.com
Fri Jul 30 03:41:27 CDT 2010


-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

On 29/07/10 22:28, Jacob P wrote:
>   Hello,
> 
> We have a PE840 with an AAC-RAID (Rocket) (rev 02) card that we are 
> trying to find out what control drivers to use for this card.

At a guess (based on the PowerEdge 850 I have here) its an Adaptec
AAR-2610SA card (6-port SATA), which uses the standard aacraid driver.

"lspci -v" should give you a little more information. for example,
another AAR card I have:

02:0c.0 RAID bus controller: Adaptec AAC-RAID (rev 01)
	Subsystem: Adaptec AAR-2410SA PCI SATA 4ch (Jaguar II)
	Flags: bus master, 66MHz, slow devsel, latency 64, IRQ 26
	Memory at c0000000 (32-bit, prefetchable) [size=64M]
	Expansion ROM at dfe00000 [disabled] [size=32K]
	Capabilities: <access denied>
	Kernel driver in use: aacraid
	Kernel modules: aacraid

> 
> Would anyone be gracious enough to point me in the right direction of 
> what packages I should be using for array / drive monitoring?
> 

I've never, personally, got very far with this. I know Adaptec have a
Java based management tool if you dig hard enough. I'm not sure if OMSA
supports these cards (they're also known as CERC cards).

Mark.

- -- 
Mark Watts BSc RHCE MBCS
Senior Systems Engineer, IPR Secure Managed Hosting
www.QinetiQ.com
QinetiQ - Delivering customer-focused solutions
GPG Key: http://www.linux-corner.info/mwatts.gpg
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v2.0.14 (GNU/Linux)
Comment: Using GnuPG with Fedora - http://enigmail.mozdev.org/

iEYEARECAAYFAkxSkDcACgkQBn4EFUVUIO20nQCgyTAUu03+SRw8e8yRJo792+4n
OU4AoJiaeJaAczMMU4i5ZyI8vglZwxqC
=FZkn
-----END PGP SIGNATURE-----



More information about the Linux-PowerEdge mailing list