Serial over LAN
rpnabar at gmail.com
Thu Jul 15 17:22:40 CDT 2010
On Thu, May 20, 2010 at 1:01 PM, Jefferson Ogata <poweredge at antibozo.net> wrote:
> 2. In BMC setup (control-E during POST), enable serial over LAN, set IP
> and password.
> ** First thing you should do in BMC setup is reset to default. The BMCs
> often ship with a weird non-default setting that will cause lots of
> serial port feedback if you try to run a getty on the serial console.
Is it possible to do this step in an automated fashion? i.e. without
using the Manual Ctrl+E?
Would ipmitool, or syscfg or another equivalent tool have the way of
setting the BMC SOL? I already set the BMC's IP and pasword using
I have ~300 machines so doing this step manually via Ctrl+E is tedious.
More information about the Linux-PowerEdge