2600 and mptscsih error Status=02h (CHECK CONDITION)

Toni Mattila tontsa at neutech.fi
Tue May 25 09:28:00 CDT 2004


Dear All,

I'm running PowerEdge 2600 with RH9's errata 
kernel. This box has been happily running for 52 
days now and I noticed from the kernel logs yesterday:

scsi : aborting command due to timeout : pid 375720461, scsi0, channel 0, 
id 2, lun 0 Read (10) 00 04 af 7a 27 00 00 40 00
mptscsih: OldAbort scheduling ABORT SCSI IO (sc=f78a9c00)
  IOs outstanding = 2
mptscsih: ioc0: Issue of TaskMgmt Successful!
SCSI host 0 abort (pid 375720461) timed out - resetting
SCSI bus is being reset for host 0 channel 0.
mptscsih: OldReset scheduling BUS_RESET (sc=f78a9c00)
  IOs outstanding = 2
SCSI Error: (0:0:0) Status=02h (CHECK CONDITION)
 Key=6h (UNIT ATTENTION); FRU=00h
 ASC/ASCQ=29h/02h "SCSI BUS RESET OCCURRED"
 CDB: 2A 00 02 27 92 0A 00 00 08 00

SCSI Error: (0:2:0) Status=02h (CHECK CONDITION)
 Key=6h (UNIT ATTENTION); FRU=00h
 ASC/ASCQ=29h/02h "SCSI BUS RESET OCCURRED"
 CDB: 28 00 04 AF 7A 27 00 00 40 00


ID2 is:
  Vendor: MAXTOR    Model: ATLAS10K4_73SCA   Rev: DFM0
  Type:   Direct-Access                      ANSI SCSI revision: 03
Attached scsi disk sdb at scsi0, channel 0, id 2, lun 0
SCSI device sdb: 143374650 512-byte hdwr sectors (73408 MB)

I ran smartctl from smartmontools and it reports nothing alarming 
on the disk itself. So should I get worried?

Here is the mptscsih boot messages:
Fusion MPT base driver 2.03.00
Copyright (c) 1999-2002 LSI Logic Corporation
mptbase: Initiating ioc0 bringup
ioc0: 53C1030: Capabilities={Initiator}
mptbase: Initiating ioc1 bringup
ioc1: 53C1030: Capabilities={Initiator}
mptbase: 2 MPT adapters found, 2 installed.
Fusion MPT SCSI Host driver 2.03.00
scsi0 : ioc0: LSI53C1030, FwRev=01000c00h, Ports=1, MaxQ=255, IRQ=72
scsi1 : ioc1: LSI53C1030, FwRev=01000c00h, Ports=1, MaxQ=255, IRQ=73

-- 
Thanks in advance, 
Toni Mattila 




More information about the Linux-PowerEdge mailing list