eth0 not coming up

Dax Kelson dax at
Thu Aug 1 00:05:00 CDT 2002

On Wed, 31 Jul 2002, Karl Zander wrote:

> >A couple things, after boot, run:
> >
> >lsmod
> >
> >Do you see the eepro100 kernel module (driver) loaded?
> lsmod does not show eepro100 loaded.

Do an:

insmod eepro100

then do a "dmesg" and see what the last ~6 lines show.  Hopefully you see 
lines that indicate the module loaded and detected the card properly. 
Verify the module is loaded and that ifconfig works.

If that works, ditch the "options eepro100" line from your modules.conf 
and then run "depmod -a".


More information about the Linux-PowerEdge mailing list