Issues with OpenManage + CentOs 5.4

Jonathan B. Horen jbhoren at alaska.edu
Wed Sep 22 13:49:37 CDT 2010


I successfully installed and ran v6.3, yesterday, on an SC1435 running
RHEL/5.5


On Wed, Sep 22, 2010 at 10:03 AM, <Wayne_Weilnau at dell.com> wrote:

> In OM 6.1 we removed many of the install blockages.  In the past, the
> installation scripts would prevent installation on any unsupported
> distribution or version.  In 6.1, these checks have been replaced with
> standard RPM dependency checks.  At run time, there are a few checks within
> our processes to ensure that we are running on Dell hardware that is not too
> old.  Note that the ability to install on a version/distribution does not
> imply that it is officially supported or that it will work.
>
> The net of this is that you should be able to install OMSA on SELinlux if
> the RPMs we are dependent on are installed.  I believe there is a good
> chance OMSA will work, but no guarantees.  Try it and see.
>
> Wayne Weilnau
> Systems Management Technologist
> Dell | OpenManage Software Development
>
> Please consider the environment before printing this email.
>
> Confidentiality Notice | This e-mail message, including any attachments, is
> for the sole use of the intended recipient(s) and may contain confidential
> or proprietary information. Any unauthorized review, use, disclosure or
> distribution is prohibited. If you are not the intended recipient,
> immediately contact the sender by reply e-mail and destroy all copies of the
> original message.
>
> -----Original Message-----
> From: linux-poweredge-bounces-Lists On Behalf Of Liberty Young
> Sent: Wednesday, September 22, 2010 11:59 AM
> To: Chris Szilagyi
> Cc: linux-poweredge-Lists
> Subject: Re: Issues with OpenManage + CentOs 5.4
>
> what about SELinux? Is it enabled?
>
> On Thu, Sep 16, 2010 at 8:29 PM, Chris Szilagyi <chris at apex-internet.com>
> wrote:
> > Hello:
> >
> > I recently set up a PowerEdge 2400 server running CentOS 5.4.  I'm trying
> to
> > get OpenManage 4.5 installed (last version that I could find, that
> supports
> > the PowerEdge 2400).  I installed everything using the supplied scripts,
> > however when I try to start the services with "srvadmin-services.sh
> start",
> > I get the following:
> >
> > Starting Systems Management Device Drivers:
> > Starting dcdbas device driver:                             [  OK  ]
> > Starting Systems Management Data Engine:
> > Starting dcstor32d:                                        [  OK  ]
> > Starting dcevt32d:                                         [  OK  ]
> > Starting OM Common Services:                               [  OK  ]
> > invcol Error: extract(): Unable to create temporary files. Please ensure
> > that there is enough space in the
> > tmp folder.
> > Starting Secure Port Server:                               [  OK  ]
> >
> > The disk has over 7 GB of free space, and permissions look OK on /tmp.
>  Has
> > anybody seen this problem or know of a solution?  So far I'm stumped.
> >
> > Thank you !!
> > --
> > Chris
> >
> > _______________________________________________
> > Linux-PowerEdge mailing list
> > Linux-PowerEdge at dell.com
> > https://lists.us.dell.com/mailman/listinfo/linux-poweredge
> > Please read the FAQ at http://lists.us.dell.com/faq
> >
>
> _______________________________________________
> Linux-PowerEdge mailing list
> Linux-PowerEdge at dell.com
> https://lists.us.dell.com/mailman/listinfo/linux-poweredge
> Please read the FAQ at http://lists.us.dell.com/faq
>
> _______________________________________________
> Linux-PowerEdge mailing list
> Linux-PowerEdge at dell.com
> https://lists.us.dell.com/mailman/listinfo/linux-poweredge
> Please read the FAQ at http://lists.us.dell.com/faq




-- 
JONATHAN B. HOREN
Systems Administrator
UAF Life Science Informatics
Center for Research Services
(907) 474-2742
jbhoren at alaska.edu
http://biotech.inbre.alaska.edu
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.us.dell.com/pipermail/linux-poweredge/attachments/20100922/24071a43/attachment.htm 


More information about the Linux-PowerEdge mailing list