Dell Power Edge R710 with CentOS

Rahul Nabar rpnabar at gmail.com
Fri May 28 14:48:49 CDT 2010


On Tue, May 18, 2010 at 6:46 AM, Stephan van Hienen
<stephan.van.hienen at thevalley.nl> wrote:
> Just install centos 5.5 and add  'options bnx2 disable_msi=1' to /etc/modprobe.conf after the first boot.

If I do modinfo bnx2 I already see:

parm:           disable_msi:Disable Message Signaled Interrupt (MSI) (int)

Do I still have to add the line to modprobe? I tried adding the line
and then modprobing bnx2 but modinfo output doesn't seem to change. Is
there a way of knowing if or not the fix was successfully applied?

-- 
Rahul



More information about the Linux-PowerEdge mailing list