Monitor RAID status on debian etch

[Nicolas Delanos]

Thanks a lot Michal and Ben.

Le 09-07-21 à 08:01, Ben a écrit :

> On Tue, 21 Jul 2009, Lazy wrote:
>
>> 2009/7/21 Nicolas Delanos <nicolas.delanos at gmail.com>:
>>
>>> When there is a problem, "Status              : Ok" change to  
>>> "Status
>>>        : Failure" ?
>>
>> Non-Critical , and I think Critical, i whould report anything other
>> than Ok as an error to be sure
>
> The best place to check possible values for different aspects of the  
> PERC is the dell MIB file:
>
> /opt/dell/srvadmin/sm/mibs/dcstorag.mib
>
> For example:
>
> -- 1.3.6.1.4.1.674.10893.1.20.130.4.1.24
> arrayDiskComponentStatus OBJECT-TYPE
>                         SYNTAX DellStatus
>                         ACCESS read-only
>                         STATUS mandatory
>                         DESCRIPTION
> "The status of the array disk itself without the propagation of any
> contained component status.
>                         Possible values:
>                                1: Other
>                                2: Unknown
>                                3: OK
>                                4: Non-critical
>                                5: Critical
>                                6: Non-recoverable"
>                         ::= { arrayDiskEntry 24 }
>
> Ben
> -- 
> Unix Support, MISD, University of Cambridge, England
> Plugger of wire, typer of keyboard, imparter of Clue
>        Life Is Short.          It's All Good.
> _______________________________________________
> Linux-PowerEdge mailing list
> Linux-PowerEdge at lists.us.dell.com
> https://lists.us.dell.com/mailman/listinfo/linux-poweredge
> Please read the FAQ at http://lists.us.dell.com/faq