need procedure to install centos 5.2 on poweredge 2950 III

[christian.peper at kpn.com]

Sebastien,

Check out this report from Dell. Linux device enumeration can the cause
of your problem, swapping eth0 and eth1 after installation.

http://breakablelinux.blogspot.com/2007/04/poweredge-2950-nics-switched-
in-linux.html

Chris. 

> -----Original Message-----
> From: linux-poweredge-bounces at dell.com 
> [mailto:linux-poweredge-bounces at dell.com] On Behalf Of 
> Sebastien Deseille
> Sent: Friday, January 09, 2009 8:34 PM
> To: linux-poweredge at dell.com
> Subject: need procedure to install centos 5.2 on poweredge 2950 III
> 
> Hello
> 
> I have strange network behaviour with a fresh centos 5.2 
> install on dell poweredge 2950 III server with 2 Broadcom 
> Netxtreme II BCM 5708 NIC.
> 
> It seem no one can help me to solve problem so i want to try 
> another thing.
> 
> My server is a single quad core xeon processor with 4Gbytes of RAM.
> I have perc 6i Raid Controler with 3 disk and two Broadcom 
> Netxtreme II BCM 5708 NIC.
> 
> Is anyone installed centos 5.2 on same server setup ?
> If yes can you reply and explain your procedure with lot of details
> 
> regards
> 
> _______________________________________________
> Linux-PowerEdge mailing list
> Linux-PowerEdge at dell.com
> http://lists.us.dell.com/mailman/listinfo/linux-poweredge
> Please read the FAQ at http://lists.us.dell.com/faq
>