PowerPath startup

[christian.peper at kpn.com]

Uhm this seems obvious, but did you run a 
chkconfig PowerPath on

To set the daemon to start after boot?
Normally, the installation should take care of this, but perhaps not.
You can reboot and check it the service is set to start using
chkconfig --list PowerPath
If it lists "off", use the cmd above to enable it and make sure it is configured to run in the runlevel you're using. Normally that would be level 3, but I've seen people using level 4 though most services are turned off in 4.

Hope it helps,
Chris.
> -----Original Message-----
> From: linux-poweredge-bounces at dell.com 
> [mailto:linux-poweredge-bounces at dell.com] On Behalf Of madunix
> Sent: Wednesday, April 15, 2009 4:53 PM
> To: linux-poweredge
> Subject: PowerPath startup
> 
> my PowerPath failed to initialize at boot but works if I run 
> manually the startup command, on RHEL5.3 64bit
> 
> [root at linux4 ~]# /etc/init.d/PowerPath start Starting PowerPath:  done
> 
> 
> How can I make it to auto starup after boot?
> 
> 
> Thanks