64bit etch poweredge PowerEdge 2950 scsi error

[Alessio Cecchi]

Il Thursday 17 July 2008 15:33:15 hai scritto:
> as i suggested, try kernel 2.6.26 ( or 2.6.25 from lenny )
>
> when you put load on the controller ( sas 6i/R ) then your file
> system wil go in readonly mode.
>
> i spend about 2 weeks of testing with this and the problem is
> the latest controllers firmware. ( from kernel.org git listings )
>
> but you can try but dont say i didnt warn you.
>
> eventually i installed xen expres 4.1
> this worked soso... when not stressing the servers controllers/harddisk
> it works, but when stressed, same errors and filesystem to read only.
>
> but good luck anyway.
>
> Louis

Thanks Louis,

on my dell PE 2970 with debian etch 64 and perc 5/i i haven't problem, works 
fine, only OMSA said the "Driver Version" in unsupported.

I just want to experiment to build this module!

Ciao
-- 
Alessio Cecchi is:
@ ILS -> http://www.linux.it/~alessice/
Assistenza Sistemi GNU/Linux -> http://www.cecchi.biz/
@ PLUG -> ex-Presidente, adesso senatore a vita, http://www.prato.linux.it
@ LOLUG -> neo-Socio http://www.lolug.net