DRAC-ERA/0 login issue

[L.P.H. van Belle]

remove the card from your server, 
boot, and shutdown again.
add the drac card again.

Now its factory default again.

this is also the to restore after a bad upgrade.

... works for me. 

Louis
 

>-----Oorspronkelijk bericht-----
>Van: linux-poweredge-bounces at dell.com 
>[mailto:linux-poweredge-bounces at dell.com] Namens Ryan Bair
>Verzonden: 2008-12-15 02:30
>Aan: quaqu at mytweakers.net
>CC: linux-poweredge at dell.com
>Onderwerp: Re: DRAC-ERA/0 login issue
>
>I'm not sure if you're clear on this point or not, but the DRAC is
>completely separate from the OS and has its own username and passwords
>which need to be initially set by entering the config utility on boot.
>
>On Sun, Dec 14, 2008 at 4:36 PM, quaqu at mytweakers.net
><quaqu at mytweakers.net> wrote:
>> Dear all,
>>
>> I have a poweredge 1750 with a drac or era/0 card, but I 
>can't log in!
>> The card is not the PCI version. I found the switch SW2 and it resets
>> the number of log-in attempts. But after a reset, logging in with
>> root/calvin does not work. Not with the webGUI, which works fine, or
>> telnet.
>> Using telnet, the response is:
>> "Dell Embedded Remote Access Controller (ERA/O)
>> Firmware Version 3.12 (Build 04.26)"
>> As OS, I installed openSUSE 11.0 with not much more than std LAMP. Do
>> I need to address this from the OS or something else? At 
>this moment I
>> have physical access, so I can push buttons etc. Does anyone have any
>> idea how I can log in to the card and control my server?
>>
>> With kind regards,
>>
>> Willem
>>
>> _______________________________________________
>> Linux-PowerEdge mailing list
>> Linux-PowerEdge at dell.com
>> http://lists.us.dell.com/mailman/listinfo/linux-poweredge
>> Please read the FAQ at http://lists.us.dell.com/faq
>>
>
>_______________________________________________
>Linux-PowerEdge mailing list
>Linux-PowerEdge at dell.com
>http://lists.us.dell.com/mailman/listinfo/linux-poweredge
>Please read the FAQ at http://lists.us.dell.com/faq