Debian/GNU Linux OMSA 5.2 package

[Hiroyuki Yoshimura]

Thank you for helping me. 

After all, does OMSA omreport storage command works by SAS5  ?

I use,
Dell PowerEdge840
SAS5iR RAID1
# uname -r
2.6.18-4-686
# cat /etc/debian_version 
4.0

by dmesg
Fusion MPT base driver 3.04.01
Fusion MPT misc device (ioctl) driver 3.04.01
mptctl: Registered with Fusion MPT base driver
mptctl: /dev/mptctl @ (major,minor=10,220)

scsi0 : ioc0: LSISAS1068, FwRev=000a3100h, Ports=1, MaxQ=286, IRQ=169
  Vendor: SEAGATE   Model: ST3300555SS       Rev: T107
  Type:   Direct-Access                      ANSI SCSI revision: 05
  Vendor: SEAGATE   Model: ST3300555SS       Rev: T107
  Type:   Direct-Access                      ANSI SCSI revision: 05
  Vendor: Dell      Model: VIRTUAL DISK      Rev: 1028
  Type:   Direct-Access                      ANSI SCSI revision: 05


I checked kernel .config.

# Fusion MPT device support
#
CONFIG_FUSION=y
CONFIG_FUSION_SPI=m
CONFIG_FUSION_FC=m
CONFIG_FUSION_SAS=m
CONFIG_FUSION_MAX_SGE=40
CONFIG_FUSION_CTL=m
CONFIG_FUSION_LAN=m 

# modprobe mptctl
#lsmod
mptbase  46176  3 mptctl,mptsas,mptscsih
# mpt-status 
ioc0 vol_id 0 type IM, 2 phy, 278 GB, state OPTIMAL, flags ENABLED
ioc0 phy 1 scsi_id 32 SEAGATE  ST3300555SS      T107, 279 GB, state ONLINE, flags NONE
ioc0 phy 0 scsi_id 1 SEAGATE  ST3300555SS      T107, 279 GB, state ONLINE, flags NONE 

I could check status of SAS5iR RAID controller. 

But,
# omreport storage controller
No controllers found 

I want to know How to Raid construction operation on debian.
Next, what should I do?