SAS Raid Controller Driver

[John]

On Fri, 2007-07-06 at 14:32 +0000, jonathanharmsall at gmail.com wrote:
> Hi Marshall
> 
> Thanks for the reply.
> 
> I did check through SAS that the RAID array had been created.
> I should have mentioned in my previous email that the installtion is
> failing when it gets to the partition section. As it can't see any
> drives the installation fails immediatly.
Have you checked to see what the raid operating mode is in in the
controler Bios?
Changing to Mass Storage for FC4 and up to Cent 4 (RHEL4) requires the
Mass Storage Setting then try the linux dd Drivers that didn't
complain....

> 
> Is there any way that I can load the drivers and manually try and mount
> the drives to see that it is the correct driver?
> 
> Regards,
> Jonathan
> 
> On 7/6/07, McDougall, Marshall (FSH) <Marshall.McDougall at gov.mb.ca> wrote:
> > >I can't get the Fedora installation to see the RAID array and the
> > >installation just aborts.
> >
> >
> > You say that "03.07-1-rhel30-all loads without a complaint" so that
> > implies to me that the install sees the controller.  Have you actually
> > created the array on that controller?
> >
> > Regards, Marshall
> >
> > _______________________________________________
> > Linux-PowerEdge mailing list
> > Linux-PowerEdge at dell.com
> > http://lists.us.dell.com/mailman/listinfo/linux-poweredge
> > Please read the FAQ at http://lists.us.dell.com/faq
> >
> 
> _______________________________________________
> Linux-PowerEdge mailing list
> Linux-PowerEdge at dell.com
> http://lists.us.dell.com/mailman/listinfo/linux-poweredge
> Please read the FAQ at http://lists.us.dell.com/faq
-- 
~/john

OpenPGP Sig:BA91F079