SAS Raid Controller Driver

[jonathanharmsall at gmail.com]

Hi Marshall

Thanks for the reply.

I did check through SAS that the RAID array had been created.
I should have mentioned in my previous email that the installtion is
failing when it gets to the partition section. As it can't see any
drives the installation fails immediatly.

Is there any way that I can load the drivers and manually try and mount
the drives to see that it is the correct driver?

Regards,
Jonathan

On 7/6/07, McDougall, Marshall (FSH) <Marshall.McDougall at gov.mb.ca> wrote:
> >I can't get the Fedora installation to see the RAID array and the
> >installation just aborts.
>
>
> You say that "03.07-1-rhel30-all loads without a complaint" so that
> implies to me that the install sees the controller.  Have you actually
> created the array on that controller?
>
> Regards, Marshall
>
> _______________________________________________
> Linux-PowerEdge mailing list
> Linux-PowerEdge at dell.com
> http://lists.us.dell.com/mailman/listinfo/linux-poweredge
> Please read the FAQ at http://lists.us.dell.com/faq
>