PE 2650 and Add in RAID Controller not being detected

Todd Lyons tlyons at ivenue.com
Tue Feb 6 17:15:30 CST 2007


-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

On Tue, Feb 06, 2007 at 02:17:26PM -0500, J. Epperson wrote:

>In a similar vein, if I were troubleshooting this, I'd want to see what
>happened if I start the machine up with no disks connected to the LSI. 
>Poster indicated that he could boot from CD and see the controller with
>disks attached (strange if it's not recognized at start up, but not

Makes sense though, since Linux does its own PCI bus scan and loads the
module that it thinks will service device(s) it finds.  No BIOS
interaction required for that.

>impossible).  I'd also want to know if it would "see" _any_ other PCI-X
>card at startup, and whether it could see a regular PCI card.  If

That sounds very reasonable, as long as the goal is determining whether
there is a disparity between PCI and PCI-X operation.  The issue as he
is stating it is that the BIOS is not doing the ROM scan.  (Apparently I
missed the fact that it was a PCI-X card so the disparity between PCI
and PCI-X could be a factor.)

- -- 
Regards...		Todd
Exponential problems need logarithmic solutions.         --Eddy Dreger
Linux kernel 2.6.17-6mdv   load average: 0.54, 0.49, 0.29
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.5 (GNU/Linux)

iD8DBQFFyQwSY2VBGxIDMLwRApKSAJ4ndNvA8nwjtStTYGyvXTVh8otCbgCfVh2W
AT6whhp5CBvnuHKAG35I4c4=
=ggue
-----END PGP SIGNATURE-----



More information about the Linux-PowerEdge mailing list