PowerVault 122T with CentOS

[Tom Brown]

> SCSI subsystem initialized
> ACPI: PCI interrupt 0000:03:0a.0[A] -> GSI 5 (level, low) -> IRQ 5
> ACPI: PCI interrupt 0000:03:0a.1[B] -> GSI 3 (level, low) -> IRQ 3
> scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.36
>         <Adaptec 3960D Ultra160 SCSI adapter>
>         aic7899: Ultra160 Wide Channel A, SCSI Id=7, 32/253 SCBs
> 
> scsi1 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.36
>         <Adaptec 3960D Ultra160 SCSI adapter>
>         aic7899: Ultra160 Wide Channel B, SCSI Id=7, 32/253 SCBs
> 
> (scsi1:A:6): 20.000MB/s transfers (10.000MHz, offset 15, 16bit)
>   Vendor: BNCHMARK  Model: VS640             Rev: 5032
>   Type:   Sequential-Access                  ANSI SCSI revision: 02
> Adaptec aacraid driver (1.1-5[2412])
> ACPI: PCI interrupt 0000:01:08.1[A] -> GSI 3 (level, low) -> IRQ 3
> percraid0: kernel 2.7-1[3170]
> percraid0: monitor 2.7-1[3170]
> percraid0: bios 2.7-1[3170]
> percraid0: serial 650c41d3
> scsi2 : percraid
>   Vendor: DELL      Model: Linux             Rev: V1.0
>   Type:   Direct-Access                      ANSI SCSI revision: 02
> SCSI device sda: 142182912 512-byte hdwr sectors (72798 MB)
> sda: Write Protect is off
> sda: Mode Sense: 03 00 00 00
> SCSI device sda: drive cache: write through
> SCSI device sda: 142182912 512-byte hdwr sectors (72798 MB)
> sda: Write Protect is off
> sda: Mode Sense: 03 00 00 00
> SCSI device sda: drive cache: write through
>  sda: sda1 sda2 sda3 sda4 < sda5 sda6 sda7 >
> Attached scsi removable disk sda at scsi2, channel 0, id 0, lun 0

where is the tape changer though... eg

scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.36
         <Adaptec 3960D Ultra160 SCSI adapter>
         aic7899: Ultra160 Wide Channel A, SCSI Id=7, 32/253 SCBs

(scsi0:A:6): 160.000MB/s transfers (80.000MHz DT, offset 127, 16bit)
   Vendor: CERTANCE  Model: ULTRIUM 2         Rev: 1801
   Type:   Sequential-Access                  ANSI SCSI revision: 03
   Vendor: DELL      Model: PV-124T           Rev: 0026
   Type:   Medium Changer                     ANSI SCSI revision: 02
scsi1 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.36
         <Adaptec 3960D Ultra160 SCSI adapter>
         aic7899: Ultra160 Wide Channel B, SCSI Id=7, 32/253 SCBs