Dual NICs poweredge 1650

Steve_Boley@Dell.com Steve_Boley at Dell.com
Wed Apr 24 10:56:00 CDT 2002


Note: You must have kernel you are running's source installed, gcc, and make
installed for this driver.  Get the driver and is as simple as #make
install.
Steve

-----Original Message-----
From: JACOB_LIBERMAN at dell.com [mailto:JACOB_LIBERMAN at dell.com]
Sent: Wednesday, April 24, 2002 10:31 AM
To: tcollier at deltacomputersystems.com; linux-poweredge at exchange.dell.com
Subject: RE: Dual NICs poweredge 1650


use intels e1000 module

-----Original Message-----
From: Toby Collier [mailto:tcollier at deltacomputersystems.com]
Sent: Wednesday, April 24, 2002 10:29 AM
To: linux-poweredge at exchange.dell.com
Subject: Dual NICs poweredge 1650



Hello, I am new to the list. I tried searching the archives, but I did not
get any responses (which I found odd). Anyway, I am having a problem getting
the Dual NIC on our PowerEdge 1650 to work with Slackware. I am not sure if
I should be using the eepro100 module or not. Maybe I just need to pass
parameters to the module? I was hoping someone here might have tried it and
could give me some advice. Thanks in advance.

-- 
Toby Collier
Webmaster
Cisco Certified Network Associate

Delta Computer Systems, Inc.
http://www.deltacomputersystems.com
228-868-3250

_______________________________________________
Linux-PowerEdge mailing list
Linux-PowerEdge at dell.com
http://lists.us.dell.com/mailman/listinfo/linux-poweredge
Please read the FAQ at http://lists.us.dell.com/faq or search the list
archives at http://lists.us.dell.com/htdig/

_______________________________________________
Linux-PowerEdge mailing list
Linux-PowerEdge at dell.com
http://lists.us.dell.com/mailman/listinfo/linux-poweredge
Please read the FAQ at http://lists.us.dell.com/faq or search the list
archives at http://lists.us.dell.com/htdig/




More information about the Linux-PowerEdge mailing list