Incompatible firmware in PERC_5_i_Integrated_ven_0x1028_dev_0x0015_subven_0x1028_subdev_0x1f03-a09-21

[Flaherty, Patrick]

Hello, 

 It appears the firmware in the
PERC_5_i_Integrated_ven_0x1028_dev_0x0015_subven_0x1028_subdev_0x1f03-a0
9-21 package is not compatible with PERC 5/i cards, or is corrupted
(25fdd0db555be4fa1d4b687e83bc7707  payload/FW5461II.rom). If you try to
run sasdupie by hand, this is the output:

<?xml version="1.0" encoding="UTF-8"?><SVMExecution lang="en"><Device
vendorID="1028" deviceID="0015" subDeviceID="1f03" subVendorID="1028"
bus="2" device="e" function="0" display="PERC 5/i Integrated Controller
0"><Application componentType="FRMW" version="5.2.2-0072" display="PERC
5/i Integrated Controller 0 Firmware"><Package version=""/><SPStatus
result="false"><Message id="2">The operation failed due to an invalid
image file.</Message></SPStatus></Application></Device><SPStatus result
= "false"><Message id="2">The operation failed due to an invalid image
file.</Message></SPStatus><RebootRequired>0</RebootRequired></SVMExecuti
on>

I downloaded firmware version 5.2.2-0072
(9a98da45c78375d234e588828b333725  FW5461II.rom), and ran sasdupie,
which updated the firmware with no issue.

So, my question is, does the package have the wrong firmware? or did the
repo give me the wrong package?

Best
Patrick


Output of lspci -vvv
RAID bus controller: Dell PowerEdge Expandable RAID controller 5
        Subsystem: Dell PERC 5/i Integrated RAID Controller
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop-
ParErr+ Stepping+ SERR+ FastB2B-
        Status: Cap+ 66MHz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 32 (32000ns min), Cache Line Size: 64 bytes
        Interrupt: pin A routed to IRQ 82
        Region 0: Memory at d80f0000 (32-bit, prefetchable) [size=64K]
        Region 2: Memory at fc5c0000 (32-bit, non-prefetchable)
[size=128K]
        Expansion ROM at fc400000 [disabled] [size=32K]
        Capabilities: [c0] Power Management version 2
                Flags: PMEClk- DSI- D1+ D2- AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-
        Capabilities: [d0] Message Signalled Interrupts: 64bit+
Queue=0/1 Enable-
                Address: 0000000000000000  Data: 0000
        Capabilities: [e0] PCI-X non-bridge device
                Command: DPERE- ERO- RBC=512 OST=4
                Status: Dev=02:0e.0 64bit+ 133MHz+ SCD- USC- DC=bridge
DMMRBC=1024 DMOST=4 DMCRS=16 RSCEM- 266MHz- 533MHz-